Pay in 4 interest-free payments of $3.75 Learn more
Ships within 48 hours · Estimated delivery Aug 17 - Aug 22
Please Note: Once a new nozzle has been installed onto a barrel
1 - Atmega2560 microcontroller with on-board peripherals
USB Port enabling users to print files stored on flash drives
are the responsibility of the customer
the bed is then automatically leveled by adjusting the z-motors at each of the four corners
40 mm Fan Voltage:24 V Please Note: Once a newThis fan is the smaller of the two fans mounted in front of the extruder and is also used inside the electronics case. These fans have a keyed connector, guarding against incorrect plug in. All fans should be kept free of dust buildup to prevent failure. *M2 3D printers purchased in November 2015 or earlier require the 12 volt version of the 40 mm fanplease be sure to select the proper voltage based on your date of purchase. If you are unsure which
US$ 500.00
US$ 500.00
US$ 500.00
US$ 500.00
US$ 500.00
US$ 500.00
US$ 500.00
US$ 18.00
US$ 500.00
US$ 500.00
