GRS 004-697 Inside Ring Engraving Holder Glendo GRS Powered by a single SR44

Powered by a single SR44 (357 type) button cell battery

Its molded rubber barrel holds a 3 lb total load and runs quietly through extended cycles — burnishing

Compatible Flex Shafts USA key-tip style flex shaft systems Not Compatible European slip-joint flex shaft systems Compatible Abrasives 3M Trizact™

free-form design

Shipping Restriction: This item cannot be shipped outside the United States or via air freight due to its aerosol/hazardous classification

GRS 004-697 Inside Ring Engraving Holder Glendo GRS Powered by a single SR44The GRS Inside Ring Engraving Holder (004 697) from Glendo GRS is a purpose built holding solution designed to secure rings during inside band engraving work. Engineered for use with GRS engraving systems, this holder gives engravers precise control and steady support when working on the interior surfaces of ring shanks a notoriously challenging area to access with standard block setups. Whether you are lettering a wedding band, adding decorative