Throttle-by-Wire Extension Harness for Harley-Davidson Length:6" designed according to the type

designed according to the type of vehicle and use

accepts stock HD lids and hardware

Add a personal message to make it special

in this case it is necessary to cut the 8-pin connector from the frame and hardwire using chart below

Although not intended for passenger use

Throttle-by-Wire Extension Harness for Harley-Davidson Length:6" designed according to the typeOur Throttle by Wire Extension Harness is ideal when adding taller risers and or bars to your Harley Davidson model with throttle by wire. Allows for a clean & simple install. The factory Throttle by Wire for 2016 later models was changed significantly with a much smaller sealed JST Connector. This allows you to change out your bars with one of our sleek plug n play extension harnesses. This harness will run through most aftermarket handlebar