charge and replace batteries and jump-start vehicles AURHTE102 Diagnose and repair heavy vehicle compression ignition engines AURHTF102 Diagnose and repair heavy vehicle diesel fuel injection systems AURTTA104 Carry out servicing operations AURTTA118 Develop and carry out diagnostic test strategies AURTTE104 Inspect and service engines AURTTK001 Use and maintain measuring equipment in an automotive workplace AURTTK102 Use and maintain tools and equipment in an automotive workplace AURTTM004 Assemble engine blocks and sub-assemblies AURTTM008 Dismantle and evaluate engine blocks and sub-assemblies AURTTM011 Recondition engine cylinder heads Electives AURAFA103 Communicate effectively in an automotive workplace AURAMA001 Work effectively with others in an automotive workplace AURETR124 Diagnose and repair compression ignition engine management systems AURETR128 Diagnose and repair instruments and warning systems AURETR129 Diagnose and repair charging systems AURETR130 Diagnose and repair starting systems AURETR132 Diagnose and repair automotive electrical systems AURHTE001 Remove and install heavy vehicle engine assemblies AURHTX104 Diagnose and repair heavy vehicle clutch systems AURHTZ101 Diagnose and repair heavy vehicle emission control systems AURTTA009 Carry out mechanical pre-repair operations AURTTA105 Select and use bearings
Core units FSKLRG008 Use simple strategies for work-related learning Elective units FSKNUM003 Use whole numbers and halves for work FSKNUM004 Use basic and familiar metric measurements for work FSKNUM005 Use familiar 2D shapes for work SKDIG001 Use digital technology for short and basic workplace tasks FSKDIG002 Use digital technology for routine and simple workplace tasks FSKDIG003 Use digital technology for non-routine workplace tasks FSKLRG002 Identify strategies to respond to short and simple workplace problems FSKLRG003 Use short and simple strategies for career planning FSKLRG004 Use short and simple strategies for work-related learning FSKLRG005 Use strategies to plan simple workplace tasks * We can develop additional elective units that are not listed on request (Please contact us for further information)
charge and leak test refrigerants - split systems UEERA0059 Prepare and connect refrigerant tubing and fittings UEERA0049 Install and start up single head split air conditioning and water heating heat pump systems UEECD0007 Apply work health and safety regulations
Units of competency HLTPOP026 Monitor and maintain sewage or effluent systems HLTPOP027 Monitor and maintain water supply HLTPOP025 Provide basic repairs and maintenance to health hardware and fixtures * We can develop additional elective units that are not listed on request (Please contact us for further information)
Core units CPCCCM2012 Work safely at heights CPCCDE3016 Identify hazards on demolition sites and apply risk management strategies CPCCDE3017 Select and use hand tools and equipment for demolition tasks CPCCDE3018 Select and use small plant and equipment for demolition tasks CPCCDE3019 Demolish small buildings and structures using hand tools and small plant and equipment CPCCDE3020 Select and use tools and equipment for hot work in the demolition industry CPCCDE3027 Read and interpret demolition site plans and drawings CPCCOM1015 Carry out measurements and calculations CPCCWHS2001 Apply WHS requirements
Assessment Kit-BSBWHS611 Develop and implement strategies that support work-related psychological health and safety UEE charge and replace batteries andOur assessment resources contain everything you need to begin assessing your learners. Our assessment resources include: Assessment Pack (Student) Trainer Assessment Pack (Marking Guide) Mapping for each unit of competency Assessment Record Tools Our assessment resources have been aligned to learner cohorts, industry needs and ACSF indicated levels. In order to achieve this, we have conducted: Industry consultation Robust validations Assessment of